Mas Trailer Tanker 2024 Carbon steel basic model camión cisterna semirremolque nueva

TANKER BASİC MODEL
DIMENSIONS:

Length: 10850 mm
Width maximum 2550 mm
Height 3750 mm
Pin - Ground clearance: 1250 mm

CHASSIS AND STRUCTURE:

Chassis: Carbon steel 100x200x5mm box section
Tanker Structure Monoblock
Single compartment
Tank capacity 30,000 liters
4mm steel

Axles

Three local axles are used, each with a load capacity of 12 tons.
It has air suspension.
The front axle is removed and can be controlled from the driver's cabin.

BRAKE SYSTEM:

"Knor" or "Wabco" brand products are used in the braking system designed according to European regulations. Equipped with automatic brake ratchets, brake valve, brake bellows (30 cylinders), brake pads (394x200), axle brakes (4 sensor 2 module EBS system). There are 2 replaceable and protected brake sockets in front of the trailer. 60+60 lt capacity air tank is installed.


ELECTRICAL SYSTEM
“Saba” Brand
2x7 pin sockets - 24V, lights in accordance with SAE standards.
Rear taillights, side marker lights, brake safety warning lights and signal lights will be installed.
There will be 2 tail and stop combination lamps.
2 turn signal combination lamps will be installed
1 license plate lamp.
The electrical system complies with European norms and is flame resistant.

PARKING LEGS
OMS brand Park Legs
Includes telescopic, mechanical conveyor gear
Dynamic Lifting Capacity : 25 Ton
Static Lifting Capacity : 50 Tons
Low Gear Position : 0.98 mm / RPM




TIRES AND RIMS:

385/65/R22.5 STARMAX PETLAS, (6 pieces)
11.75 x 22.5, JANTSA rim (6 pcs)

KING-PIN:

Turkish brand OMS is used. It is a 74080 standard bottom removable king pin and is made according to SAE standards as 8 bolt type. It has E certificate.


PAINTING:

All parts are carefully cleaned before painting.
First protective primer and epoxy is used for painting.
Two coats of high quality paint are applied to the tanker.
The tanker is painted white. It can be painted in any desired color. If a different color is requested, it will be reflected as an extra cost.

KURTUBA manhole cover:

It is mounted on the tanker by welding the lower neck plate to the upper part of the tanker. The upper plate is connected to the throat plate with sealed gaskets and screws. Mushroom type vents are mounted on top.

KURTUBA Valve :

3" flanged ball valve is made of ST37 material and galvanized against corrosion. The ball is made of ST37 material. Fuel and heat resistant Teflon material is used in sealing parts.

ACCESSORIES

6 pieces of mudguards
1 wheel chock
1 6 kg fire extinguisher box
1 spare wheel space
1 water tank 30 lt.
1 Folding ladder
Holder for two 3.5 m drain hoses

Note: Please contact us for your production requests in special sizes.